Kenmore 385.18836090 – 385.18836 Sewing Machine Manual

 

 

 

Kenmore 385.18836090 – 385.18836 Sewing Machine Manual.

Includes:
Machine threading.
Bobbin winding.
Change the needle.
Set the pressure dial.
Three step zigzag.
Dropping the feed dogs.
Buttonhole making.
Zipper insertion.
Thread tension adjustment.
Reverse stitch control.
Thread cutter.
Twin needle stitching.
Replace the light bulb.
Oiling.
Cleaning.
Much more!

72 page instruction/owners manual.

Kenmore 385.18836090 – 385.18836 Sewing Machine Manual.

36 Stitch

 

Kenmore sewing machine manuals

manualsoncd.com

sewingpartsplus.com

 

White 2999 Sewing Machine Instruction Manual

 

 

 

White 2999 Sewing Machine Instruction Manual.

Includes:
Machine threading.
Change the needle.
Pattern selector dial.
Bobbin winding.
Presser foot pressure dial.
Thread tension adjustment.
LCD Screen.
Reverse stitch lever.
Buttonholes.
Zigzag stitch.
Twin needle sewing.
Changing light bulb.
Insert zippers.
Troubleshooting.
Cleaning.
Much more!

40 page instruction/owners manual.

White 2999 Sewing Machine Instruction Manual.

 

White sewing machine manuals

manualsoncd.com      

sewingpartsplus.com

 

Singer 776 Stylist Sewing Machine Instruction Manual

 

 

Singer 776 Stylist Sewing Machine Instruction Manual.

Includes:
Threading your machine.
Bobbin winding.
Choosing needle and thread.
Threading bobbin case.
Needle threading.
Tension adjustment.
Adjusting dials.
Presser foot lifter.
Free-arm sewing.
Hints on special fabrics.
Zigzag sewing.
Straight stitch.
Decorative stitches.
Sewing knits and stretch fabrics.
Buttons.
Free-motion sewing.
Replacing slide plate
Replacing the light bulb.
Accessories.
Much more!

72 page instruction/owners manual.

Winding the bobbin - Singer 776 Stylist Sewing Machine Instruction Manual

Preparation It is best to wind the bobbin before you thread the machine.

1. Turn hand will until needle is at its highest position.

2. Disengage hand wheel by loosening the hand wheel knob with your right hand while holding the hand wheel with your left.

3. Open the slide plate.

4. Lift out the bobbin.

 

Winding steps

1. Place thread spool on spool pin over the spool pin felt. Lead thread between tension discs around thread post and through small hole in the bottom from the inside out.

2. Place bobbin on spindle and engage latch by pressing it toward the bobbin.

3. Hold thread end and start the machine. Break off thread and when winding is well under way.

4. When required amount of threat has been wound, disengage bobbin latch. (full bobbin will automatically release). Cut thread and remove bobbin from spindle.

5. Tighten hand wheel knob by turning it away from you with your right hand while holding the hand wheel with your left hand.

 

Threading the bobbin case

1. Hold bobbin and so that the thread unwinds in the direction shown, and put bobbin in bobbin case.

2. Pull thread into notch in bobbin case, drawing under the tension spring and into slot.

3. Draw approximately 4 inches of thread diagonally across the bobbin.

4. Close slide plate, allowing the thread to enter the slot in the slide plate.