Elna Lotus EC ZZ TSP Sewing Machine Instruction Manual.
Includes:
Threading machine.
Bobbin winding.
Buttonhole.
Centering the needle.
Foot control and cord.
Special zigzag or overcasting stitch.
Rotary hook.
Thread take-up lever.
Upper tension dial.
Thread tensions.
Length of stitch.
Lubrication.
Maintenance.
Troubleshooting.
Oiling points.
Light bulb.
Cleaning.
Much more!
40 page instruction/Owners manual.
Models: Lotus EC, ZZ, TSP.
Winding the bobbin – Elna Lotus EC ZZ TSP Sewing Machine Instruction Manual
For the usual sewing jobs, you will do well to use a medium-size needle.
1. Turn the safety dial to bobbin winding.
Make sure that it is properly engaged.
2. Place the bobbin on the bobbin Winder with the holes on top.
3. Pull out the spool pin and place the spool on it.
4. Raise the thread guide and passed the thread through it.
5. Wind the end of the thread around the bobbin by hand, in the direction indicated.
6. Wind by machine, while pressing lightly on the spool with the
left hand, so that the thread will be stretched and the bobbin wound
more evenly.
Important: watch the bobbin and stop winding just before the bobbin is completely full.
7. Turn the safety dial to sewing. It will remain in that position as long as you use the machine.
Inserting the bobbin
8. Drop it into rotary hook, with the holes facing upward. There is
no bobbin case. Past the thread through the slot (a). Retain the bobbin
with the left index finger. Bring the thread round to the front, at the
angle Illustrated (b).
9. Close the rotary Hook cover and draw the thread into the notch
with a slight tug to the rear. It then snaps into the tension spring
automatically.
10. Open the rotary Hook cover and check by pulling the thread
gently towards the rear. It should not come out of the slot. If it does,
repeat the operation as explained under 8 and 9 above.
11. To change the bobbin, pull the extractor down into the bobbin. When it is released, the bobbin is automatically removed.
