Kenmore 158.1750 Sewing Machine Instruction Manual.
Includes:
Winding the bobbin.
Picking up bobbin thread.
Placement of needle.
Thread tension assembly.
Stitch length control lever.
Nomenclature plate.
Presser foot thumb screw.
Inserting pattern disc.
Sewing on plastic films.
Threading the double needle.
Adjusting your sewing machine for good stitches.
Feed dog control.
Sewing light switch.
Writing and monogramming.
Parts list.
Oiling.
Cleaning.
Much more!
34 page instruction/owners manual.
Kenmore models:
158.1750
158.17500
158.175001
Kenmore 158.1750 Sewing Machine Instruction Manual
PLACEMENT OF NEEDLE
Raise the needle bar to its highest position by turning hand wheel toward you.
Loosen needle clamp screw.
Hold the needle with flat side away from you.
Slip the needle as far as it will go into the needle clamp, and tighten the needle clamp screw.
SETTING STITCH LENGTH
The stitch length lever controls the stitch length. Set lever to any
desired stitch length position between O and 4 by turning knob until
the indicator is aligned with the stitch length number desired.
The red mark indicates the settling for a satin stitch. This will vary
slightly depending upon the type or material to be sewn. At No. 4 the
longest stitch is obtained. The size or stitch you select will depend on
the fabric you are sewing. Straight stitching is done with stitch width
control on O setting, or by removal of pattern disc.
SETTING STITCH WIDTH
Insert disc 1. Turn the stitch width knob to the desired setting
between O and 4 on the knob. Zigzag stitch width increases from 1 to 4.
Straight stitching is possible only with control on O setting or by
removal of pattern disc.
When sewing with the double needle, the stitch width control must not be advanced beyond 2 1/2 setting.
SEWING ON BUTTONS
Align two boles of button with slot of presser foot and lower foot to hold securely. Drop feed dog. Turn hand wheel by hand until needle point is just above button. Adjust stitch width so that needle will align with a hole of button. Turn hand wheel again by hand so that needle goes into second hole, readjust stitch width if necessary. Stitch a number of times, turning hand wheel manually. Finish sewing with an extra 2 inches of thread, draw thread to reverse side and tie securely.
If using a 4 hole button repeat the above procedure.
NOTE: To make a small thread shank when sewing on a flat button, place a straight pin or needle between the holes of the button.
