Necchi 6015 Omega Sewing Machine Instruction Manual.
Includes:
Threading machine.
Changing the needle.
Bobbin winding.
Adjusting thread tension.
Dropping the feed dogs.
Reverse stitch lever.
Stitch length dial.
Two way speed control.
Sewing buttons.
Zigzag stitching.
Needle chart.
Sewing light.
Buttonholes.
Zipper application.
Drive belt tension.
Troubleshooting.
Cleaning.
Much more!
48 page 6015 sewing machine instruction manual
Necchi 6015 Omega Sewing Machine Instruction Manual
Additional Necchi sewing manuals here
Changing needles
Raise the needle by turning the balance wheel toward you and lower the presser foot. Turn off the power switch.
Loosen the needle clamp screw by turning it towards you.
Remove the needle from the clamp.
Insert the needle into the needle clamp with the flat side away from you.
When inserting the needle into the clamp, push it up as far as it will go and tighten the clamp screw firmly with the screwdriver.
Winding the bobbin
Lift up the spool pin. Place the spool of thread on the holder with the thread coming off the spool as shown.
Attach the large spool holder pressing it firmly against the thread spool.
The small spool holder is used with narrow or small thread spools.
Additional Spool Pin
The additional spool pin is used to wind extra bobbins without unthreading the machine.
To use, insert the additional spool pin in the hole. Place the felt and the spool on the pin.
Remove the bobbin
Gently push down the slide plate and pull it out onto the extension table.
Lift out the bobbin.
